广东工业大学学报 ›› 2015, Vol. 32 ›› Issue (2): 69-73.doi: 10.3969/j.issn.1007-7162.2015.02.013

• 综合研究 • 上一篇    下一篇

基于FPGA的LTE解调参考信号生成的实现

魏国廷,刘立程,陈裕通,李伟儒   

  1. 广东工业大学 信息工程学院,广东 广州 510006
  • 收稿日期:2013-10-08 出版日期:2015-05-30 发布日期:2015-05-30
  • 作者简介:魏国廷(1989-),男,硕士研究生,主要研究方向为LTE系统物理层关键技术.
  • 基金资助:

    广东省自然科学基金资助项目(S2011040003956)

The Implementation of the Generation of LTE Demodulation -Reference Signals Based on FPGA

Wei Guo-ting, Liu Li-cheng, Chen Yu-tong, Li Wei-ru   

  1. School of Information Engineering, Guangdong University of Technology, Guangzhou 510006, China
  • Received:2013-10-08 Online:2015-05-30 Published:2015-05-30

摘要: 参考信号在LTE(Long Term Evolution,长期演进)中具有重要的作用,主要用于接收端提取信息并用于信道估计、均衡等.根据LTE系统相关的物理层协议规范,结合现场可编程逻辑门阵列(FieldProgrammable Gate Array,FPGA)设计技术,给出了解调参考信号生成的设计流程图.并采用ALTERA公司Cyclone III系列的FPGA芯片实现了解调参考信号的生成.仿真结果表明,基于FPGA的解调参考信号生成实现方案能够达到LTE相关协议规定的要求.

关键词: 长期演进; 物理上行控制信道; 解调参考信号; FPGA实现

Abstract: The reference signal plays an important role in LTE(Long Term Evolution), which is mainly used to extract information for channel estimation, equalization and etc.. According to the LTE physical layer protocol specification, the paper presents the design flow chart of the generation of the demodulation reference signal with the field programmable gate array (FPGA) design techniques by using the FPGA chip of ALTERA-s Cyclone III series. Simulation results show that the FPGAbased demodulation reference signal generation program can achieve the requirements of LTErelated specifications.

Key words: long term evolution; physical uplink control channel; demodulation reference signal; FPGA implementation

No related articles found!
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
No Suggested Reading articles found!