广东工业大学学报 ›› 2007, Vol. 24 ›› Issue (4): 53-56.

• 综合研究 • 上一篇    下一篇

微型电火花装置直接驱动电极丝的研究

  

  1. 广东工业大学机电工程学院; 哈尔滨工业大学机电工程学院; 广东工业大学机电工程学院 广东广州510006; 黑龙江哈尔滨150001; 广东广州510006;
  • 出版日期:2007-11-08 发布日期:2007-11-08
  • 基金资助:

    国家自然科学基金资助项目(5977020);广东工业大学博士基金资助项目(063040)

Study of Directly Driven Electrode Thread for Miniaturized EDM Device

  1.  (1.Faculty of Electromechanical Engineering,Guangdong University of Technology,Guangzhou 510006,China;2.Faculty of Electromechanical Engineering, Harbin Institute of Technology,Harbin 150001,China)
  • Online:2007-11-08 Published:2007-11-08

摘要: 针对微小型电火花加工装置电极夹持困难、辅助加工时间长等问题,提出了直接驱动电极丝的方法,采用超声马达作为电极的驱动器.利用有限元分析方法对超声马达进行模态分析,求解出超声马达的最佳振动模态和驱动频率.对整个系统进行了实验研究,验证了该系统的可行性. 更多还原

关键词: 电火花加工; 直接驱动电极丝; 微型电火花装置; 有限元分析;

Abstract: In order to resolve the problem of long assistant machining time,miniaturized EDM device with electrode direct driving mechanism has been designed,using an ultrasonic motor as its driver.The analysis of vibration modal is accomplished by using ANSYS.Further more,the optimal vibration modal and driving frequency have been implemented by animate function of ANSYS.The test of the whole system has been conducted,and the feasibility of the system has been verified.

Key words: electron discharge machining(EDM); directly driven electrode thread; miniaturized EDM device; Finite Element Method(FEM);

[1] 刘维东,赵万生,狄士春,王士民,栾英艳.  小型电火花加工装置中电极的驱动与控制[J]. 电加工. 1998(02)

[1] MASUZAWA T.State of the Art of Micromachining. Annals of the CIRP . 2000

[2] MASUZAWA T.Micro-EDM. Anon.InternationalSymposium for Electro machining(ISEM-13) . 2001

[3] SHEU Dong-Yea,MASUZAWA T.Development of Large-scale production of microholes by EDM. Anon.Inter-national Symposium for Electro Machining(ISEM-13) . 2001

[4] Naotske Mohri,Katsushi Furutani,Kazubisa Shirai,et al.Forced discharge dispersion by dot matrix method. Annals of the CIRP . 1997
No related articles found!
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
No Suggested Reading articles found!