广东工业大学学报 ›› 2019, Vol. 36 ›› Issue (05): 56-62.doi: 10.12052/gdutxb.190008

• 综合研究 • 上一篇    下一篇

考虑层间接触的旧水泥混凝土路面加铺厚沥青层的力学分析

吕惠卿, 方一钱, 尹应梅   

  1. 广东工业大学 土木与交通工程学院, 广东 广州 510006
  • 收稿日期:2019-01-10 出版日期:2019-08-21 发布日期:2019-08-06
  • 作者简介:吕惠卿(1976-),女,讲师,主要研究方向为道路工程.E-mail:lhuiqing@163.com
  • 基金资助:
    国家自然科学基金青年基金资助项目（51508109）；广东省公路管理局项目（粤公研2017-7）

A Mechanical Analysis of Thicker Asphalt Layer Overlaid on Old CCP Considering Interlayer Contact

Lyu Hui-qing, Fang Yi-qian, Yin Ying-mei   

  1. School of Civil and Transportation Engineering, Guangdong University of Technology, Guangzhou 510006, China
  • Received:2019-01-10 Online:2019-08-21 Published:2019-08-06

HTML

PDF (PC)

2755

摘要： 基于试验路段省道120线的路面技术状况，利用有限元软件ABAQUS建立旧水泥路面加铺厚沥青层的三维力学分析模型，并考虑了旧路面与加铺层的层间接触和旧路面间接缝.首先计算分析了结构的温度场，然后分析了结构在温度荷载和车辆荷载耦合作用下调平层厚度对结构力学响应的影响及各结构层的功能需求.得出以下结论：在典型高温天气下，面层顶部的温度高于55℃；温度场变化幅度较大的范围在0~30 cm，增加加铺层厚度可降低因旧路面结构引起的温度应力；加铺层承受了较大的竖向变形，上面层和调平层承受较大的拉应力，是路面由上而下开裂和由下向上疲劳开裂的主要原因；上面层承受着较大的压应力和剪应力，同时下面层和调平层也承受了较大的剪应力；增加调平层厚度，可有效降低调平层的拉应力、压应力和剪应力，可以较大降低对旧路面结构的抗拉强度要求，从而增强了结构抗反射裂缝能力和抗疲劳能力；根据力学分析，给出了各加铺层混合料设计建议.研究成果为改善道路材料设计和提高加铺结构耐久性提供力学理论依据.

关键词: 道路工程, 加铺厚沥青层, 水泥混凝土路面, 力学分析

Abstract: Based on the pavement technical condition of the test highway S120, a three-dimensional model of the thicker asphalt layers overlaying on the existing concrete cement pavement (CCP) is established by the finite element software ABAQUS, which considers the interlayer contact between the existing CCP and overlay layers and the joints in CCP. First, the temperature field of the structure is calculated and analyzed, and then the influence of the thickness of adjustment layer on the mechanical response of the structure under the coupling action of temperature and traffic load is studied. At last the functional requirements of each structural layer are analyzed. The following conclusions are drawn:under the local typical high temperature, the temperature in the top surface is higher than 55℃, and the temperature field varies greatly between 0~30 cm; increasing the thickness of the overlay layers reduces the temperature stress caused by the existing CCP. The overlay layers are subjected to larger vertical displacement and the upper surface layer and adjustment layer are subjected to larger tensile stress, which is the main causes of Surface-down cracking and Bottom-up fatigue cracking. The upper surface layer is subjected to large compressive and shear stresses, while the lower surface layer and adjustment layer are also subjected to large shear stresses; as the thickness of adjustment layer increases, the tensile, compressive and shear stress of adjustment layer can be effectively reduced, and the required tensile strength of the old CCP structure can be greatly reduced, which enhances the anti-reflective crack ability and anti-fatigue ability of structure; according to the mechanical analysis, the proposals of the Mix Designing of the overlaying layers are given. The research results providing a theoretical basis for improving the design of road materials and improving the durability of overlay structures.

Key words: highway engineering, overlay thick asphalt layer, cement concrete pavement, mechanical analysis

中图分类号: 

  • U416.2
[1] 吕惠卿. 破损水泥混凝土路面的修复设计及可靠性研究[D]. 广州: 广东工业大学, 2008.<br /> [2] 弋晓明, 张宏博, 张瑜洪, 等. 旧水泥路破碎改造后加铺半刚性基层沥青路面结构破损机理分析[J]. 中外公路, 2011, 31(1): 74-77<br /> [3] 徐华. 半刚性基层沥青混凝土路面反射裂缝扩展和疲劳寿命研究[D]. 南宁: 广西大学, 2012.<br /> [4] 黄今, 陈拴发, 李祖仲. 旧水泥混凝土路面沥青加铺层反射裂缝的研究进展[J]. 材料导报, 2013, 27(3): 77-80<br /> HUANG J, CHEN S F, LI Z Z. Advances in reflection cracking of asphalt overlay on old concrete pavement [J]. Materials Review, 2013, 27(3): 77-80<br /> [5] 杨斌. 旧水泥混凝土路面沥青加铺层结构研究[D]. 西安: 长安大学, 2005.<br /> [6] 彭亚军, 戴志敏. 加铺沥青面层在高速公路路面改造中的应用[J]. 中外公路, 2004, 24(4): 139-142<br /> [7] CHEN D H, WON M. CAM and SMA mixtures to delay reflective cracking on PCC pavements [J]. Construction and Building Materials, 2015, 96: 226-237<br /> [8] YU Y, SUN L. Effect of overlay thickness, overlay material, and pre-overlay treatment on evolution of asphalt concrete overlay roughness in LTPP SPS-5 experiment: a multilevel model approach [J]. Construction and Building Materials, 2018, 162: 192-201<br /> [9] WANG J. Analysis the control techniques of reflection crack on asphalt overlay of old cement concrete pavement [J]. Applied Mechanics and Materials, 2012, 204-208: 1945-1948<br /> [10] GHAUCH Z G, ABOUJAOUDE G G. Strain response of hot-mix asphalt overlays in jointed plain concrete pavements due to reflective cracking [J]. Computers & Structures, 2013, 124: 38-46<br /> [11] SOUZA F V, CASTRO L S. Effect of temperature on the mechanical response of thermo-viscoelastic asphalt pavements [J]. Construction and Building Materials, 2012, 30: 574-582<br /> [12] KAI L, Fang W. Computer modeling mechanical analysis for asphalt overlay coupling action of temperature and loads [J]. Procedia Engineering, 2011, 15: 5338-5342<br /> [13] 陈飞, 胡光伟. 旧水泥混凝土路面上沥青加铺层力学分析的有限元法[J]. 公路, 2001(12): 38<br /> [14] OZER H, AL-QADI I L, WANG H, <i>et al</i>. Characterisation of interface bonding between hot-mix asphalt overlay and concrete pavements: modelling and in-situ response to accelerated loading [J]. International Journal of Pavement Engineering, 2012, 13(2): 181-196<br /> [15] XUE Q, LIU L, ZHAO Y, <i>et al</i>. Dynamic behavior of asphalt pavement structure under temperature stress coupled loading [J]. Applied Thermal Engineering, 2013, 53: 1-7<br /> [16] 朱兴一. 沥青混凝土的细观力学模型及数值模拟[D]. 杭州: 浙江大学, 2010.<br /> [17] 张东, 黄晓明, 赵永利. 基于内聚力模型的沥青混合料劈裂试验模拟[J]. 东南大学学报(自然科学版), 2010, 40(6): 1276-1281<br /> ZHANG D, HUANG X M, ZHAO Y L. Simulation of indirect tension test of asphalt mixtures based on cohesive zone model [J]. Journal of Southeast University (Natural Science Edition), 2010, 40(6): 1276-1281<br /> [18] 钮凯健, 李昶. 基于内聚力模型的沥青路面低温缩裂数值模拟[J]. 公路交通科技, 2012, 29(6): 11-15<br /> NIU K J, LI C. Numerical simulation of low temperature shrinkage cracking of asphalt pavement based on cohesive zone model [J]. Journal of Highway and Transportation Research and Devel- opment, 2012, 29(6): 11-15<br /> [19] 孙丽娟. 考虑层间接触的半刚性基层沥青路面热应力耦合分析[D]. 杭州: 浙江大学, 2013.<br /> [20] CHO S H, KIM Y R. Verification of time-temperature superposition principle for shear bond failure of interlayers in asphalt pavements [J]. Transportation Research Record: Journal of the Transportation Research Board, 2016, 2590: 18-27<br /> [21] 张涛, 李东兴. 旧水泥路面沥青加铺层疲劳开裂研究[J]. 建筑技术, 2016, 47(8): 761-763<br /> ZHANG T, LI D X. Study on fatigue crack of asphalt overlay on old cement pavement [J]. Architecture Technology, 2016, 47(8): 761-763<br />
[1] 孙晓龙, 袁俊申, 于华洋, 覃潇, 尹应梅. 反光标线材料及其逆反射性能影响因素研究进展[J]. 广东工业大学学报, 2021, 38(04): 81-94.
[2] 黄太昌, 尹应梅, 吕建兵, 李俊禧. 不同RAP掺量温拌再生改性沥青抗变形性能研究[J]. 广东工业大学学报, 2019, 36(03): 103-110.
[3] 孙晓龙, 马强, 邹超, 贺绍华, 孟涛, 王娉诺. 多因素状况下热阻涂料固化特性及机理研究[J]. 广东工业大学学报, 2019, 36(01): 100-106.
[4] 尹应梅, 张荣辉, 林思能. 城市道路交叉口沥青加铺层路面结构分析与设计[J]. 广东工业大学学报, 2011, 28(3): 91-94.
[5] 廖辉, 吴百海, 肖体兵, 李卫华. 海洋钻柱运动补偿的非线性动力学分析[J]. 广东工业大学学报, 2011, 28(1): 1-4.
[6] 陈连云; 刘桂雄;. 具有独特悬架系统的旅行车操纵稳定性仿真[J]. 广东工业大学学报, 2009, 26(2): 5-.
[7] 尹应梅; 张荣辉;. 旧水泥混凝土路面改建的防水排水设计[J]. 广东工业大学学报, 2009, 26(1): 2-.
Viewed
Full text


Abstract

Cited
  Shared   
  Discussed   
No Suggested Reading articles found!
版权所有 © 2017 《广东工业大学学报》编辑部
地址：广州市东风东路729号广东工业大学 邮编：510090
电话：020-37626653,020-37626139,020-37626396
邮箱：xbzrb@gdut.edu.cn
本系统由北京玛格泰克科技发展有限公司设计开发