广东工业大学学报 ›› 2019, Vol. 36 ›› Issue (05): 63-70.doi: 10.12052/gdutxb.180174

• 综合研究 • 上一篇    下一篇

三氧化二铝对环氧树脂固化动力学及热降解动力学的影响

张英明1, 王兵毅1, 余坚1, 郝志峰1, 柯勇2, 陈毅龙2   

  1. 1. 广东工业大学 轻工化工学院, 广东 广州 510000;
    2. 景旺电子科技(龙川)有限公司, 广东 河源 517300
  • 收稿日期:2018-12-12 出版日期:2019-08-21 发布日期:2019-09-23
  • 通信作者: 郝志峰(1971-),女,教授,主要研究方向为高分子材料的功能改性应用.E-mail:haozhifeng3377@163.com E-mail:haozhifeng3377@163.com
  • 作者简介:张英明,男,硕士研究生,主要研究方向为高分子材料的功能改性以及应用.
  • 基金资助:
    广东省应用型科技研发专项资金项目（2016B090930004）

Effects of Aluminum Oxide on Curing and Thermal Decomposition Kinetics of Epoxy Resin

Zhang Ying-ming1, Wang Bing-yi1, Yu Jian1, Hao Zhi-feng1, Ke Yong2, Chen Yi-long2   

  1. 1. School of Chemical Engineering and Light Industry, Guangdong University of Technology, Guangzhou 510006, China;
    2. Kinwong Electronic Technology (Longchuan) Co., Ltd, Heyuan 517300, China
  • Received:2018-12-12 Online:2019-08-21 Published:2019-09-23

HTML

PDF (PC)

2854

摘要： 采用热分析法研究了高含量Al2O3填料对环氧树脂（E51）/二氨基二苯甲烷（DDM）体系的固化表观活化能、热降解动力学和性能的影响.非等温差式扫描量热法（DSC）固化动力学研究表明，加入Al2O3体系的反应活化能由51.49 kJ/mol降低至48.12 kJ/mol；用n级非等温动力学法分析获得了固化反应的动力学参数.利用热重分析研究了环氧固化物体系的热降解动力学，用FWO方法计算固化物降解活化能结果表明，Al2O3粉体对E51/DDM体系初始分解活化能影响不大，当降解率达到30%时，Al2O3粉体对E51/DDM体系分解有明显的抑制作用.热重红外联用测试结果表明，甲烷、羰基化合物、胺和双酚A是E51/DDM热分解过程中的主要产物，Al2O3粉体能提高E51/DDM体系的热稳定性.动态热机械研究表明，Al2O3的加入增大了环氧树脂固化产物的储能模量.DSC测试结果表明，Al2O3加入后，体系的玻璃化转变温度由114.16℃提高到121.51℃.

关键词: 环氧树脂, 三氧化二铝, 固化动力学, 热降解动力学

Abstract: The effects of high content Al2O3 particles on the apparent activation energy, thermal decomposition kinetics and properties of epoxy resin (E51)/4, 4'-Diaminodiphenylmet (DDM) system were investigated by a thermal analysis. The results on the curing kinetics of non-isothermal differential scanning calorimetry (DSC) showed that the addition of Al2O3 promoted the curing reaction. The activation energy of the E44/DDM system was reduced from 51.49 kJ/mol to 48.12 kJ/mol after 80%Al2O3 addition. In addition, the kinetic parameters of the curing reaction were obtained by the n order model. Thermo-gravimetric analyzer was used to study the thermal decomposition kinetics of the epoxy curing system. The FWO method was used to calculate the activation energy of the degradation. The results showed that the addition of Al2O3 powder had little effect on the initial decomposition activation energy of the 80%E51/DDM system. When the degradation rate reached 30%, the Al2O3 powder had obvious inhibitory effect on the decomposition of E51/DDM system. The results of TG-IR test showed that carbon oxides, methane, carbonyl compounds, amines and aromatic compounds are the main products in the process of E51/DDM thermal decomposition. Al2O3 powder can improve the thermal stability of the E51/DDM system. Dynamic mechanics showed that the addition of Al2O3 increased the modulus of storage of epoxy resin cured products. DSC results showed that the addition of Al2O3 powder increases the glass transition temperature from 114.16℃ to 121.51℃ of the system.

Key words: epoxy resin, Al2O3, curing kinetics, thermal degradation kinetics

中图分类号: 

  • TQ320
[1] ZHANG, B L, TA NG, G L, S HI, K Y, et al. A study on the properties of epoxy resin toughened by a liquid crystal-type oligomer[J]. Journal of Applied Polymer Science, 2015, 71(1):177-184
[2] 周正伟, 白瑞成, 任慕苏, 等. 多官能团环氧树脂体系的固化反应[J]. 高分子材料科学与工程, 2011, 27(8):61-64 ZHOU Z W, BAI R C, REN M S, et al. Curing reaction of multifunctional epoxy resin[J]. Polymer Material Science & Engineering, 2011, 27(8):61-64
[3] 杜伯学, 孔晓晓, 李进, 等. 高导热环氧树脂复合电介质研究现状[J]. 绝缘材料, 2017, 50(8):1-8 DU B X, KONG X X, LI J, et al. Research status of epoxy resin composite dielectrics with high thermal conductivity[J]. Insulation Materials, 2017, 50(8):1-8
[4] WANG F, DRAZAL L, QIN Y, et al. Mechanical properties and thermal conductivity of graphene nanoplatelet/epoxy composites[J]. Journal of Materials Science, 2015, 50(3):1082-1093
[5] FERDOSIAN F, YUAN Z, ANDERSON M, et al. Thermal performance and thermal decomposition kinetics of lignin-based epoxy resins[J]. Journal of Analytical and Applied Pyrolysis, 2016, 119(82):124-132
[6] JIAO C, ZHANG C, DONG J, et al. Combustion behavior and thermal pyrolysis kinetics of flame-retardant epoxy composites based on organic-inorganic intumescent flame retardant[J]. Journal of Thermal Analysis and Calorimetry, 2015, 119(3):1759-1767
[7] ARADHANA R, MOHANTY S, NAYAK S. High performance epoxy nanocomposite adhesive:Effect of nanofillers on adhesive strength, curing and degradation kinetics[J]. International Journal of Adhesion and Adhesives, 2018, 84(8):238-249
[8] 郑伟峰, 周来水, 袁铁军, 等. 颗粒Al2O3增强环氧树脂复合材料的微波固化动力学及性能[J]. 高分子材料科学与工程, 2017, 33(10):65-71 ZHENG W F, ZHOU L S, YUAN T J, et al. Effects of modified halloysite nanotubes and ammonium polyphosphate on the flame retardancy and mechanical property for silicone rubber[J]. Polymer Materials Science & Engineering, 2017, 33(10):65-71
[9] 张进, 董红星, 陈野, 等. 羧甲基纤维素钠对环氧树脂固化行为及性能的影响[J]. 高分子材料科学与工程, 2013, 29(3):89-93 ZHANG J, DONG H X, CHEN Y, et al. Effects of carboxymethyl cellulose on the cure behaviors and properties of epoxy[J]. Polymer Materials Science & Engineering, 2013, 29(3):89-93
[10] KISSINGER H. Reaction kinetics in different thermal analysis[J]. Analysis Chemistry, 1957, 29(11):1702-1706
[11] OZAWA T. A modified method for kinetic analysis of thermoanalytical data[J]. Thermal Analysis, 1976, 9(3):369-373
[12] SBIRRAZZUOLI N. Is the friedman method applicable to transformations with temperature dependent reaction heat?[J]. Macromolecular Chemistry & Physics, 2010, 208(14):1592-1597
[13] WU S Q, LIU Y Y. Thermal stability, thermal decomposition and mechanism analysis of cycloaliphatic epoxy/4, 4-dihydroxydiphenylsulfone/aluminum complexes latent resin systems[J]. Journal of Wuhan University of Technology Materials Science, 2012, 27(6):1061-1067
[14] FATEMEH F, YUAN Z, ANDERSON M, et al. Thermal performance and thermal decomposition kinetics of lignin-based epoxy resins[J]. Journal of Analytical & Applied Pyrolysis, 2016, 11(119):124-132
[15] 吉小利, 徐国财, 王君. 纳米氮化硅对环氧树脂固化反应的影响研究[J]. 热固性树脂, 2009, 24(5):17-20 JI X L, XU G C, WANG J. Effect of nano Si3N4 on the cure reaction of epoxy resin[J]. Thermosetting Resin, 2009, 24(5):17-20
No related articles found!
Viewed
Full text


Abstract

Cited
  Shared   
  Discussed   
No Suggested Reading articles found!
版权所有 © 2017 《广东工业大学学报》编辑部
地址：广州市东风东路729号广东工业大学 邮编：510090
电话：020-37626653,020-37626139,020-37626396
邮箱：xbzrb@gdut.edu.cn
本系统由北京玛格泰克科技发展有限公司设计开发