车用纳米润滑油添加剂热力学性质模拟分析

广东工业大学学报 ›› 2010, Vol. 27 ›› Issue (1): 39-41.

车用纳米润滑油添加剂热力学性质模拟分析

广东工业大学机电工程学院，广东广州510006

出版日期:2010-03-25 发布日期:2010-03-25
作者简介:刘芳(1984-)，男，硕士研究生，主要研究方向为汽车节能和排放控制

A Study of Thermodynamic Properties of NanOcrystalline Additives to Lubricating Oil for Vehicles

Faculty of Electromechanical Engineering，Guangdong University of Technology，Guangzhou 5 10006，China

Online:2010-03-25 Published:2010-03-25

摘要/Abstract

摘要： 模拟了多个不同粒径cu 纳米粒子升温熔化过程．模拟结果及分析表明，纳米粒子熔点随其直径单调增加，并逐步向大块晶体过渡；纳米颗粒抗磨减摩机理不同于传统的油性剂和极压剂，正是通过改变摩擦方式、表面修复等来减小摩擦磨损．

关键词: 纳米；润滑油；分子动力学模拟；热力学性质；摩擦磨损

Abstract: It studies the temperature rise process of Cu nanoparticles．The melting point of Cu nanoparticles is lower than that of bulk，and it decreases with the decreasing size of nanoparticles．The premehing phenomenon was observed in different—size nanoparticles．The mechanism is different from that of traditional antiwear additives．The resuh indicates that the mode of friction is changed or a thin film is formed．

Key words: nanoerystalline；lubricating oil；molecular dynamics simulation；therm odynamic properties；friction and attritinn

刘芳, 熊锐, 唐智. 车用纳米润滑油添加剂热力学性质模拟分析[J]. 广东工业大学学报, 2010, 27(1): 39-41.

LIU Fang, XIONG Rui, TANG Zhi. A Study of Thermodynamic Properties of NanOcrystalline Additives to Lubricating Oil for Vehicles[J]. Journal of Guangdong University of Technology, 2010, 27(1): 39-41.

参考文献

[1]曹茂盛，关长斌，徐甲强．纳米材料导论[M]．哈尔滨：哈尔滨工业大学出版社，2001．

[2]Tatasov S．Study of friction by nanocopper additives to motor oil[J]．Wear，2002，252：63-69．

[3]王平，郑少华，苏登成，等．几种无机纳米粒子在润滑油中抗磨性对比研究[J]。润滑与密封，2006，181(9)：157-159．

[4]董凌，陈国需，方建华，等．si—Sn型复合纳米粒子添加剂的摩擦磨损和自修复性能[J]．石油炼制与化工，2008，39(11)：39-44．

[5]张家玺，刘琨，胡献国．纳米金刚石颗粒对发动机润滑油摩擦学特性的影响[J]．摩擦学学报，2002，22(1)：44-47．

[6]郭延宝，徐滨士，许一．原位检验润滑油添加剂自修复性能的方法探讨[J]．润滑与密封，2005，169(3)：68-69．

[7]Nanda K K，Maisels A，Kruis F E．Higher Surface Energy of Free Nanoparticles[J]．Phys Rev Lett，2003(91)：106102-106106．

[8]Lamber R，Wetjen s，Jaeger N I．Size dependence of the lattice parameter of small palladium particles[J]．Phys Rev，2005(B51)：10968-10971．

[9]Bowdon F P，Tabor D．The Friction and Lubrication of Solids[M]．Oxford：Clarendon Press，2004．

Metrics

Viewed

Full text

Abstract

Cited

Shared

Discussed