广东工业大学学报 ›› 2017, Vol. 34 ›› Issue (01): 45-49.doi: 10.12052/gdutxb.160057

• 综合研究 • 上一篇    下一篇

18650圆柱形电芯的产热行为研究

王子缘, 张国庆, 高冠勇, 吕又付   

  1. 广东工业大学 材料与能源学院, 广东 广州 510006
  • 收稿日期:2016-04-05 出版日期:2017-01-09 发布日期:2017-01-09
  • 通信作者: 张国庆(1963-),男,教授,博士生导师,主要研究方向为新能源及节能环保.E-mail:pdzgq008@126.com E-mail:pdzgq008@126.com
  • 作者简介:王子缘(1990-),男,博士研究生,主要研究方向为电池热管理.
  • 基金资助:

    广东省应用型科技项目(2015B01035010);广州市科技计划项目(2016201604030056)

A Study of Heat Generation Behavior of 18650 Cylindrical Battery

Wang Zi-yuan, Zhang Guo-qing, Gao Guan-yong, Lyu You-fu   

  1. School of Material and Energy, Guangdong University of Technology, Guangzhou 510006, China
  • Received:2016-04-05 Online:2017-01-09 Published:2017-01-09

摘要:

随着新能源汽车的不断发展,提高动力电池运行时的热安全性倍受关注.通过实验方法测试出18650单体电芯在恒流1 C放电倍率下的电压、电流、温度及时间数据,通过能量守恒估算电芯的理论产热值为3 901.51 J,并且计算出电芯的平均比热容与平均发热功率分别为5.37 J/(g·K)与1.08 W.同时采用计算机仿真的方式,模拟出18650电池在1 C恒流放电时的表面/截面温度云图,与实验得出的数据对比并进行验证,实现其最高温度的误差值小于等于1℃,为后续的电动汽车热灾害评估打下理论基础.

关键词: 电芯产热, 热安全, 能量守恒

Abstract:

With the continuous development of new energy vehicles, increasing the thermal safety of the power battery attracts more attention. The data of current, voltage, temperature and time of the 18650 single cell are tested under the constant current 1 C discharge rate, the theoretical calorific value of the cell estimated to be 3 901.51 J based on law of conservation of energy, and the average specific heat and the average heating power is calculated through experimental method to be respectively 5.37 J/(g·K) and 1.08 W. At the same time, the surface/section temperature image of the 18650 single cell through 1 C constant current discharge is simulated by the way of computer simulation. Compared with the experimental data and verified, the error of the maximum temperature is less than or equal to 1℃, which lays a theoretical foundation for the follow-up evaluation of the electric vehicle thermal disaster.

Key words: battery heat generation, heat safety, energy conservation

中图分类号: 

  • TK112

[1] 饶中浩, 张国庆. 电池热管理[M]. 北京:科学出版社, 2015, 7-8.
[2] RAO Z H, ZHAO Y M, HUANG C L, et al. Recent Developments in Drying and Dewatering for Low Rank Coals[J]. Progress in Energy and Combustion Science, 2015, 46:1-11.
[3] 王子缘, 张国庆, 吴伟雄, 等. 一种磷酸铁锂动力电池热管理系统实验研究[J]. 电源技术, 2016(1):47-49. WANG Z Y, ZHANG G Q, WU W X, et al. An experiment study on performance of LiFePO4 battery thermal management system[J]. Power technology, 2016(1):47-49.
[4] RAO Z H, WANG S F, ZHANG Y L. Thermal management with phase change material for a power battery under cold temperatures[J]. Energy Sources, PartA:Recovery, Utilizationand Environmental Effects. 2014, 36(20):2287-2295.
[5] SHARMA A, TYAGI V V, CHEN C R, et al. Review on thermal energy storage with phase change materials and applications[J]. Renew Sust Energ Rev, 2009, 13(2):318-345.
[6] ZHOU D, ZHAO C Y. Experimental investigations on heat transfer in phase change materials (PCMs) embedded in porous materials[J]. Appl Therm Eng, 2011, 31(5):970-977.
[7] RAO Z H, WANG S F, ZHANG Z G. Energy saving latent heat storage and environmental friendly humidity-controlled materials for indoor climate[J]. Renewable & Sustainable Energy Reviews, 2012, 16(5):3136-3145.
[8] RAO Z H, WANG S F, PENG F F. Self diffusion of the nano-encapsulated phase change materials:A molecular dynamics study[J]. Applied Energy, 2012, 100(5):303-308.
[9] RAO Z H, WANG S F, PENG F F, et al. Dissipative particle dynamics investigation of microencapsulated thermal energy storage phase change materials[J]. Energy, 2012, 44(1):805-812.
[10] RAO Z H, WANG S F, WU M C, et al. Molecular dynamics simulations of melting behavior of alkane as phase change materials slurry[J]. Energy Conversion and Management, 2012, 64(1):152-156.
[11] QIU J G, ZHANG G Q, YANG X Q, et al. A study on structure-performance relationship of overcharged 18650-size Li4Ti5O12/LiMn2O4 battery[J]. ThermAnalCalorim, 2014, 118(5):1413-1418.
[12] WU W X, ZHANG G Q, KE X F, et al. Research on the preparation and enhanced cooling effect of composite phase change material for electronic thermal management[J]. Energy Conversion and Management, 2015, 101(1):278-284.
[13] RAO Z H, WANG S F, ZHANG G Q. Simulation and experiment of thermal energy management with phase change material for ageing LiFePO4 power battery[J]. Energy Conversion and Management. 2011, 52(12):3408-3414.
[14] RAO Z H, ZHANG G Q. Thermal properties of paraffin wax based composites containing graphite[J]. Energy Sources, Part A:Recovery, Utilization, and Environmental Effects, 2011, 33(7):587-593.
[15] EAVES S, EAVES J. A cost comparison of fuel-cell and battery electric vehicles[J]. Journal of Power sources, 2004, 130(1/2):208-212.
[16] RAO Z H, ZHANG G Q, WU Z J. Thermal properties of paraffin/graphite composite phase change materials in battery thermal management system[J]. Energy Materials:Materials Science and Engineering for Energy Systems. 2009, 4(3):141-144.
[17] KIZILEL R, LATEEF A, Sabbah R, et al. Passive control of temperature excursion and uniformity in high-energy Li-ion battery packs at high current and ambient temperature[J]. Journal of Power Sources, 2008, 183(1):370-375.
[18] 吴忠杰, 张国庆. 混合动力车用镍氢电池的液体冷却系统[J]. 广东工业大学学报, 2008, 25(4):28-31. WU Z J, ZHANG G Q. The Liquid cooling system of the ni-mh battery pack for hybrid electric vehicles[J]. Journal of Guangdong University of Technology, 2008, 25(4):28-31.
[19] 张国庆, 马莉, 张海燕, 等. HEV电池的产热行为及电池热管理技术[J]. 广东工业大学学报, 2008, 25(1):1-4. ZHANG G Q, MA L, ZHANG H Y, et al. Heat generation behavior of ev battery and its thermal management technology[J]. Journal of Guangdong University of Technology, 2008, 25(1):1-4.

[1] 曾繁武, 熊锐, 吴坚, 杜锡滔, 朱敏思. 能量平衡模型的涡轮增压器控制[J]. 广东工业大学学报, 2018, 35(01): 56-60.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
No Suggested Reading articles found!